full hood lining

anybody ever fitted a full hood ling to a Holden van that did not come out with one? any help / advice would be appreciated.

cheers Richo.

You will need a hood bow kit if you want the factory look.

Jason at StickThis sells them: http://stickthisdecals.com.au/hq-wb/hoodling-bow-kits/

Regards, Smooth

I bought the kit from Sticky not very impressed so far, i have been to the trimmer and no one can work out hot the jagged thingy goes along the back above the tail gate. that will be something to check out at the Holden Day tomorrow. anyway i have found a trimmer who will sought it all out and fit it for about $800.00. which is more than i was hoping to pay but there is not a lot of trimmers around who do this stuff.
the hood lining that i bought from Rare Spares looks good, i am too far into it now so i have to keep going.

cheers

richo wrote:I bought the kit from Sticky not very impressed so far, i have been to the trimmer and no one can work out hot the jagged thingy goes along the back above the tail gate.

I don't know about Jason's customer service but others seem to like his products. My personal dealings with him aren't so good. The jagged thingy is welded in from memory. Didn't it come with instructions? for hole positions for the bows etc?

I'm surprised you got this bow set so fast.

Regards, Smooth

richo wrote:I bought the kit from Sticky not very impressed so far, i have been to the trimmer and no one can work out hot the jagged thingy goes along the back above the tail gate. that will be something to check out at the Holden Day tomorrow. anyway i have found a trimmer who will sought it all out and fit it for about $800.00. which is more than i was hoping to pay but there is not a lot of trimmers around who do this stuff.
the hood lining that i bought from Rare Spares looks good, i am too far into it now so i have to keep going.

cheers

That aint cheap just filling his own pocket find yourself another trimmer thats willing to help and not just grab the money even if you have to travell that bit further just my opinion but your choice

I might be able to help you out ,Try here

https://www.facebook.com/xtrim.motortrimming

From memory the genuine saw tooth that goes across the rear tailgate was pressed in by the factory.
I haven't seen the kit from sticthis but I imagine you could pop rivet it in ,Hate to weld it in the wrong spot..
Give X trim a call it wont hurt to get a second quote .Plus a lot would be determined by what type of material you get it done in .
I spoke to Luke and he'll need to measure to quote properly..

Worse comes to worse bring it over and we'll fit it together ,made one many moons ago

If you need something welded I can drag my tig out and do it on the spot if you need